Maunfeld MVCE59.4HL.SZ-BK, Инструкция по использованию

Страница: 27 / 40

27
ELECTRICAL CONNECTION

The installation of this appliance and the connection to the electrical network should be
entrusted only to an electrician perfectly to the fact of the normative regulations and which
respects them scrupulously.

Protection against the parts under tension must be ensured after the building-in.

The data of connection necessary are on the stickers place on the hob casing near the
connection box.

The connection to the main must be made using an earthed plug or via an omnipolar
circuit breaking device with a contact opening of at least 3 mm.

The electrical circuit must be separated from the network by adapted devices, for example:
circuit breakers, fuses or contactors.

If the appliance is not fitted with an accessible plug, disconnecting means must be
incorporated in the fixed installation, in accordance with the installation regulations.

The inlet hose must be positioned so that it does not touch any of the hot parts of the hob
or even.

If the electrical supply is restricted, means of all-pole disconnection must be accessible
and incorporated in the fixed wiring in accordance with the wiring rules.
Caution!
This appliance has only to be connected to a network 230 V~ 50/60 Hz
Connect always the earth wire.
Respect the connection diagram.
The connection box is located underneath at the back of the hob casing. To open the cover use a
medium screwdriver. Place it in the slits and open the cover.
* calculated with the simultaneous factor following the standard EN 60 335-2-6
Connection of the hob
Setting up the configurations:
For the various kinds of connection, use the brass bridges which are in the box next the terminal
Monophase 230V~1P+N
Put a bridge between terminal 1 and 2.
AЭЭКМС ЭСО ОКЫЭС Эo ЭСО ЭОЫЦТЧКЭО “ОКЫЭС”, ЭСО ЧОЮЭЫКХ N Эo ЭОЫЦТЧКХ 4, ЭСО PСКЬО L Эo oЧО oП ЭСО
terminals 1 or 2.
Biphase 400V~2P+N
AЭЭКМС ЭСО ОКЫЭС Эo ЭСО ЭОЫЦТЧКЭО “ОКЫЭС”, ЭСО ЧОЮЭЫКХ N Эo ЭОЫЦТЧКХ 4, ЭСО PСКЬО L1 Эo
the
terminals 1 and the Phase L2 to the terminal 2.
Caution! Frequent loosening and screwing of the screws on the connection box risks
damaging the efficiency of the tightness once screwed. It is therefore
advisable to keep screwing and unscrewing to a minimum.
Ensure that the cables are correctly inserted and tightly screwed down.
We cannot be held responsible for any accident resulting from incorrect connection or
which could arise from the use of an appliance which has not been earthed or has been
equipped with a faulty earth connection
Mains Connection Cable diameter Cable Protection calibre
230V~ 50/60Hz 1 Phase + N 3 x 2,5 mm²
H 05 VV - F
H 05 RR - F
25 A *
400V~ 50/60Hz 2 N 4 x 1.5 mm²
H 05 VV - F
H 05 RR - F
16 A *