Charging the Mattingly Wireless Mouse CCTV
The Mouse has a built-in lithium rechargeable battery. Before using the Mouse, charge it
until the indicator light turns green (up to 6 hours). If the battery charge is too low, the
Mouse will not operate correctly.
1.
Turn off the Mouse by sliding its on/off button (Feature#5) to “off”.
2.
Plug power adaptor into a wall socket.
3.
Plug the end of the power adaptor into the Mouse DC-in hole (Feature#10).
4.
The charging light will be red when the Mouse is charging; green indicates the
charging is complete (Feature#6).
5.
The Mouse will operate for several hours and then will need to be charged again
(follow steps#1-4 above). Note: while the Mouse is in use, the charging red/green
light will not be on. When the Mouse is ready to be charged again, the picture on
the TV will begin to diminish in quality. However, you may recharge the Mouse at
any time you wish.
6.
Note: the power adaptor can only be used for one purpose at a time: either it is
plugged into the Mouse to charge it, or it is plugged in to the Receiver to power it.
If you find that having a second power adaptor would be helpful, one can be
ordered for you.
How to Use the Mattingly Wireless Mouse CCTV
1.
Remove the power adaptor from the Mouse, and plug it into the black end of the
Y-shaped power/video cable that is attached to the Receiver (Feature#11). This will
provide power to the Receiver. Put the Receiver power button (Feature#8) in the
on position; the power indicator on the Receiver will light (Feature#9). Note: the
Receiver does not charge the Mouse; it only sends the wireless signal to the Mouse.
It can also hold the Mouse when the Mouse is not being used.
2.
Insert the yellow end of the Y-shaped power/video cable into one of your
television’s yellow video-in ports. (If needed, refer to your television owner’s
manual for more information about locating the video-in port). Note: if your
television does not have a video-in port, an alternative RF Modulator can be
ordered for you.