15
T50/T100 PTM – User Guide – Version 2 Issue 1
Installation – Print Head Set-up
7. Unscrew and remove the
Blanking-Plate
from the desired head-mounting-position.
Figure 10 - Re-positioning the print head
8. Unscrew the
Head-Retaining-Clamp’s
two screws from underneath the
Ink-Reservoir
.
Make sure that the print head is held securely, it is heavy.
9. Carefully re-position the head in to the required position. Secure it with the
Head-
Retaining-Clamp
and its two screws.
Note: It may be required, in installations where the print target does not travel
horizontally, that the print head needs to be tilted. For further information refer to “Tilting
a Print Head” on page 17.
10. Make sure that both the cables and the tubing to the print head are positioned so that
they are free from risk of damage. Make sure that the tubing is not crushed or kinked.
Caution: If the ink tubing is kinked printing problems will occur.
11. Mount the
Blanking-Plate
in the position that the print head was originally. Use the three
screws to secure it.
12. Mount the
Reservoir-Cover
back on to the
Ink-Reservoir
and secure it with the five
screws.
Blanking-Plate
and screws
Head-Retaining-Clamp
Cable-Bar
Содержание VIAcode T100
