INST
ALLA
TION
GUIDE
GB-5
Moving and Installing
Removing the Anchor Bolts
Four anchor bolts keep the interior of the washing machine in place while it’s being moved.
They need to be removed before installation. Use a spanner (not supplied) and following the
instructions below.
Don’t run the washing machine without removing the bolts, as this can cause excessive
vibration.
To remove the anchor bolts:
Use a spanner to loosen the four bolts out
1.
horizontally. They are located at the rear
side of the washing machine.
Pull the bolts out horizontally.
2.
Push the four cover caps (included with
3.
your accessories) into the respective bolt
holes.
You’ll need the anchor bolts again if
you move the washing machine, so
make sure you keep them safe.
Moving the Washing Machine from One Location to Another
Make sure to fix the anchor bolts prior to moving the washing machine.
Before you move the washing machine
Shut the tap and run the washing machine to drain the water. Drain any remaining water
•
from the pump hose.
Depressurise the water supply hose and remove it.
•
Disconnect the mains cable.
•
Attach the anchor bolts.
•
