20
Installing Memory Modules
For this mainboard, you must use 168-pin 3.3V non-buffered Du-
al In-line Memory Modules (DIMMs). The memory chips are
standard SDRAM (Synchronous Dynamic Random Access
Memory). The table below shows the supported frequencies.
Frontside Bus
(FSB)
Frequency
System Memory
Bus (SMB)
Frequency
100 MHz
100 MHz
100 MHz
133 MHz
Installation Procedure
The mainboard accommodates three memory modules. You
must install at least one module in any of the three slots. Each
module can be installed with 64 MB to 512 MB of memory.
Total capacity is 3GB.
1. Align the memory module with the slot. The DIMM
slots are keyed with notches and the DIMMs are keyed
with cutouts so that they can only be installed correctly.
Check that the cutouts on the DIMM module edge
connector match the notches in the DIMM slot: