Matrix u7xe-01, Руководство по обслуживанию

Страница: 62 / 75

58
CHAPTER 9: PART REPlACEMENT gUiDE
9.20 TESTiNg THE BikE
oNCE THE UNiT oR REPlACEMENT PART iS fUlly iNSTAllED AND ASSEMBlED AND
PRoPERly PlACED oN THE flooR, USE THE folloWiNg iNSTRUCTioNS To SETUP
AND TEST THE MACHiNE:
1) Check that the console is set for bike.
a. Press ENTER, 3, 0, 0, 1, ENTER on the lower number keypad to enter Service Mode.
b. Press SETUP on the display.
c. Press MACHINE TYPE on the display.
d. Press BIKE on the display.
e. Press UPRIGHT on the display.
f. Press the BACK and HOME keys to return to normal function.
2) Enter the serial number of the frame into the console. To do so:
a. Press ENTER, 3, 0, 0, 1, ENTER on the lower number keyapd, Service Mode will appear on the display.
b. Press SETUP on the display.
c. Press SERIAL NUMBER on the display.
d. Press PLATFORM on the display.
e. Enter the last 8 digits of the serial # from the base frame of the unit (see Section 1.1 for serial number location).
f. Press OK on the display to save the serial number.
g. Press the HOME key to return to normal function.
3) Without hitting start or entering any program modes, sit on the bike and hold the handlebars while pedaling to simulate exercising. While
moving, listen for any odd noises or squeaks.
4) After stopping movement, press the green GO key and begin pedaling.
5) Grasp the hand grips to check for proper heart rate response.
6) Press the level up and down buttons on the console and hand grips to make sure resistance is fully functional.
7) If everything functions properly, stop pedaling and the unit will reset to normal operation within 30 seconds.