T3x Error Codes LCD Console Board W / MEEEX LCB
2
ERROR CODES
Errors are divided in speed related errors (E1) , console memory related error (E2) , and elevation related errors (E3 /
E6). System should be properly calibrated (if possible) before attempting to troubleshoot error codes.
The following table contains standard error codes. Other error codes are enabled for development purposes but
cannot be remedied via engineering variables. Error codes can be remedied in some conditions by system calibration
or require toggle of system power to reset
Maintenance Lamp
Blue Light:
Normal Opertation Mode: When the treadmills accumulated distace reaches the 5,000 mile mark
the Blue light will be displayed meaning the it is time for general maintenance to be performed. This light will
then come on at every 5,000 mile interval. To turn off the light after you have finished the maintenance hold
the incline
↓
and the speed
-
at the same time for 3 seconds.
Red Light:
Normal Operation Mode: This light will occure when there is a Error sent to the console display.
To fix this please see the Error Code guide number and follow the instruction on how to fix the problem.
Service Information
For faster service please have the following information ready.
Serial Number
Production Date:
This information is located on the front of the elevation rack.
Additional information needed:
Start Speed
Motor Decal information
Motor Pad under motor
CODE DESCRIPTION
1
Speed Range (usually caused by calibration)
Speed Stall (could be missing speed sensor)
AC power wires could be loose
2
Console Memory Loss
3
Elevation out of range / Elevation movement stall
6
Console signal to LCB but no movement