Matrix C3x, Руководство пользователя

Страница: 9 / 12

9
EMERGENCY STOP
LEVER (ALL MODELS)
AUTO STOP SENSOR
(ALL MODELS)
CONTROL ZONE
(C5X, C7XE, C7XI)
PROPER USAGE
MOUNTING THE CLIMBMILL
1. Stand directly behind the ClimbMill. Grasp either the upper or lower handle
bars and step onto the ClimbMill until you are within comfortable reach of
the console, emergency stop lever, and remote handlebar controls.
2. There are two emergency stop buttons the ClimbMill. An emergency stop
lever is located on the console mast below the display, and an emergency
stop button is located on the lower right side handlebar.
3. The CONTROL ZONE will bring the step surfaces to a complete stop upon
detecting an object. The AUTO STOP SENSOR will bring the step surfaces to
a complete stop upon detecting an object under the bottom step.
4. To determine proper workout position, stand on the steps within comfortable
reach of the console. Maintain a constant distance from the console and
remote handlebar controls. Keep your knees slightly bent at all times.
CLIMBMILL SPM (STEPS PER MINUTE)
LEVEL 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25
SPM 24 30 36 42 48 54 60 66 72 78 84 90 96 102 108 114 120 126 132 138 143 148 153 158 162
POWER
The power must be plugged into the power jack,
which is located in the front of the equipment
near the stabilizer tube. The power switch is
located next to the power jack. Make sure it is in
the ON position. Unplug cord when not in use.
WARNING!
Never operate equipment if it has a damaged cord
or plug, if it is not working properly, if it has been
damaged, or immersed in water. Contact Customer
Tech Support for examination and repair.
LEVELING THE EQUIPMENT
Locate a level, stable surface to position the equipment. The equipment has levelers located
below the bottom step. To access the levelers, remove the end caps (C3x, C3xe) or CONTROL
ZONE (C5x, C7xe and C7xi). CAUTION: There is an electrical plug located under the CONTROL
ZONE and will need to be unplugged before the cover can be completely removed. Use
an allen wrench to level the unit. Once stable, replace parts as they were removed.
A carpenter’s level is recommended.
NOTE: There are only two levelers on the equipment.
WARNING!
Our equipment is heavy, use care and additional help if necessary when
moving. Failure to follow these instructions could result in injury.