8
Parallel mode
Independent mode
Remarks:
1. Lightly press the "one-key series/parallel/function menu button" on the left once the power supply will enter the
series working state, and the current window will prompt "SE" series and parallel indicator lights to show green, as
shown in the figure "series mode", the output should Connect the negative terminal of CH1 and the positive
terminal of CH2, and the main circuit "OUTPUT2" button controls the power on/off working status.
2. Lightly press the “one-key series/parallel connection/function menu button” on the left. The secondary power
supply will enter the series/parallel operation state, and the current window will prompt the “PA” series/parallel
indicator to show red, as shown in the figure “Parallel Mode”. When the output is recommended to be connected to
the positive and negative ends of CH2, the main circuit "OUTPUT2" button controls the on/off working status of the
power supply. If the current is too large, it is recommended to use a suitable wire to connect the CH1 and CH2
terminals to the positive and the positive externally. Negative and negative are connected together.
3. Tap the left "one-key series/parallel/function menu button" three times, the power supply will return to
independent working state, as shown in the figure "independent mode", the series and parallel indicator lights are
off, and CH1 and CH2 are no longer associated.
4.4 Menu setting operation Long press the left "one-key series/parallel/function menu button" power supply will
enter the menu setting mode, the setting content is as follows:
1. Power-on parameter retention setting: SE1 P-ST ON/OFF (ON is to retain the data at the last power-off, OFF is to
retain the factory default value, use the CH1 current knob to switch menu steps, and use the CH2 voltage knob to
switch ON/OFF Status, tap "One-key series/parallel/function menu button" to exit the menu.)
