MSC-XD0816L Product Manual
Command to enable syncing matrices of two router systems. Usually used for creating a 3D matrix from two
router systems, which will result in one router controlling the left 3D channels and the other router controlling
the right channels. When enabled, this option synchronizes matrix crosspoint changes to the router IP address
assigned with the
. This command should only be enabled with one of the two routers (the
primary router). This value is stored and recalled on power up.
Command
Description
RemoteSync
Query current value of remote router syncing.
RemoteSync 0 | 1
Enable or disable remote router syncing (1 or 0 respectively).
Examples
>RemoteSync
0
>RemoteSync 1
>FrameIP 192.168.2.61
>
The first command in the above examples queries the current value of the remote sync option, which returns 0
(disabled, the default). The second command enables remote syncing and the final command sets the IP address
of the router to sync (secondary router).
3.11.37 S Command
Routers and MSC-GCP2U32 only
Query the current matrix routing state. Source values for all levels of every destination are shown. This
command without an argument is equivalent to the
with no arguments. If an argument value of '1'
is supplied, then the matrix state is displayed with labels. The state of each destination is displayed, one per
line, in the format:
“DestNLvl1”:”SrcLvl1”,”DestNLvl2”:”SrcLvl2”,...
Example
>S1
“Dest1”:”Src4”,”Dest1”:”Src4”
“Dest2”:”Src3”,”Dest2”:”Src3”
“Dest3”:”Src2”,”Dest3”:”Src2”
“Dest4”:”Src1”,”Dest4”:”Src4”
The example above is output from a two level (Video and Audio for example) 4x4 matrix with sources routed in
reverse order, except destination 4, which has a 2nd level break away which is routed from source 4.
3.11.38 SerBaud Command
NOTE:
Superseded by the
ctl.serial.baud
and
ctl.serial2.baud
Query or assign the RS-232 serial port baud rate. The default value is 115200. This value is stored and recalled
on power up.
Page 46 of 61
© 2013-2018 Matrix Switch Corporation