Matrix Switch Corporation MSC-CP64X1E, Руководство по эксплуатации продукта

Страница: 18 / 55

MSC-CP64X1E Product Manual
Numeric String
Decimal (123) 1 to 3 decimal digits Unquoted Commands with string arguments
automatically interpret argument as
string (spaces and commas not
allowed).
Hex (0x3D) 0xNN where NN are 2 hex digits
from 0-9, A-F or a-f Double quoted One or more characters surrounded
by double quotes (“An Argument”).
Single quoted One or more characters surrounded
by single quotes ('An Argument').
Table 5: Basic Argument Types
Arguments are shown in the Help command output surrounded by square brackets '[Arg]' or parenthesis '(Arg)'.
Square brackets indicate an optional argument and parenthesis indicate a required argument. Any optional
argument specified requires that all prior optional arguments are also specified. Table 6 lists currently used
command argument types.
Argument Valid Range Meaning
Boolean 0/1, T/F, True/False Boolean true or false value.
Cmd String MASCOT command.
Cond String Condition statement. See PanelCond C ommand .
Dest 1-N Destination number (N = Count of destinations)
IP D.D.D.D IP address string argument, specified as 4 decimal numbers from 0 to 255
separated by periods.
Json String JSON formatted string, the structure of which depends on the command.
The JSON string should be quoted in single quote characters when
specifying a JSON value in a command.
Label String A string label argument, max of 8 characters.
Lvl 1-N Level number (N = Count of system levels)
Netmask D.D.D.D Network mask string argument, specified as 4 decimal numbers from 0 to
255 separated by periods. Must be a valid IPv4 netmask.
Number Numeric value. Valid values depends on command.
Preset 0-9 Preset number (preset 0 is special Startup preset)
Parameter Parameter identifier. See System Parameters .
Src 1-N or 0 Source number (N = Count of sources), 0 acts as mute (if supported).
String String A generic string argument (max length depends on the command).
Value A general value. Value type depends on setting. See System Parameters .
Table 6: Command Argument Types
3.6 System Parameters
MASCOT protocol version 3.0 adds commands for setting and querying configuration and other system
parameters. These commands greatly simplify the MASCOT command set and supersede several configuration
Page 18 of 55 © 2013-2018 Matrix Switch Corporation www.matrixswitch corp.com