Matrix Orbital HTT70 Series, Руководство по оборудованию

Страница: 8 / 21

MATRIX ORBITAL 7 Phone: 403.229.2737
Email: support@matrixorbital.ca
Type A HDMI Port
The HTT uses a Type A HDMI 1.0 port to receive video data from its host/source and is only compatible
with unencrypted video signals. HDCP video signals are not supported.
When properly connected, the HTT will require 5V at 55mA (minimum) from the HDMI source in order
to read the display’s EDID settings.
Figure 4: Type A HDMI Port
Table 4: Type A HDMI Port
Pin Function Pin Function
1 TMDS Data 2+ 11 TMDS Clock Shield
2 TMDS Data 2 Shield 12 TMDS Clock-
3 TMDS Data 2- 13 CEC (Not connected)
4 TMDS Data 1+ 14 Reserved
5 TMDS Data 1 Shield 15 SCL
6 TMDS Data 1- 16 SDA
7 TMDS Data 0+ 17 DDC/CEC Ground
8 TMDS Data 0 Shield 18 +5V Power
9 TMDS Data 0- 19 Hot Plug Detect
10 TMDS Clock+
Mini-B USB Communication Connector
The USB header must be connected to the host in order for the touch screen to be functional, as touch
communication occurs over USB. The Mini USB header is also used to access the HTT’s touch firmware,
and configure certain HTT settings through the HTT Utility Program. If necessary, up to 500mA of power
can be provided through the Mini-USB header to power the HTT.
Figure 5: Mini USB Connector
Table 5: Mini USB Pinout
Pin Function
1 Vcc
2 D-
3 D+
5 Gnd