OVERVIEW:
FRONT PANEL:
1.
MAINS POWER SWITCH
- This powers the unit on or off
2.
HIGH INPUT
- Allows signal to pass through all available gain stages for more
saturation (Overdrive/Distortion)
3.
LOW INPUT
- Less saturation due to one less gain stage
4.
GAIN CONTROL
- Overdrive/Distortion level - The gain works from left to right
increasing in saturation as the control is turned clockwise
5.
TONE CONTROLS
- Each knob controls the different frequencies of the amplifier
6.
VOLUME CONTROL
- Controls the output volume level
7.
SIGNAL INDICATOR
- Gives indication of how much power the amp is providing at a
given load. (see page 5)
REAR PANEL:
1
. EFFECTS LOOP RETURN
- Power amplifier input; use a shielded 1/4” cable from the
output of your effects (see page 6 for details)
2.
EFFECTS LOOP SEND
- Pre-amplifier output; use a shielded 1/4” cable to connect to
your effects (also D.I. out. See page 6 for details)
3.
SEND LEVEL -
Sets the volume level of the pre-amplifier output to match your effects
(also D.I. pre-amp volume level. See page 6 for details)
4.
OUTPUTS A/B
- see page 6 for examples of suitable loading.
5.
IEC INLET
- Inlet for power cable (Do not remove the earth ground lug from the cable)
1
2
3
4
5
1
2
3
4
5
6
7
3