MTX-IND-V2 Industrial Featured GSM-GPRS terminal modem http://www.matrix.es
MTX-IND-V2 User Manual V.1.1
Page. 5
Subject to change without prior notice
1. INTRODUCTION
1.1
Description
The MTX-IND-V2 is a GSM-GPRS terminal modem based on the Cinterion TC65i module. It has many
industrial environment features and is enclosed in a waterproof IP65 housing.
The MTX-IND-V2 is the perfect choice for applications that are installed outdoors and need a mains AC
power supply, to control high loads and communicate with RS232-RS422-RS485 serial bus.
The MTX-IND-V2 terminal is able to handle data calls, SMS, Fax, and GPRS connections with its powerful
TCP-IP stack communication with Internet Services:
TCP, UDP, HTTP, FTP, SMTP, POP3.
The MTX-IND-V2 includes Java embedded programmability and a full range of I/Os. The unit can host and
control your Java J2ME application allowing you to develop and embed your code directly inside,
shortening time to market and reducing costs. The new internal Watchdog supervisor avoids hangs-up.
Alternatively, it can be used as a powerful standalone GPRS modem with its intrinsic TCP/IP stack.
The MTX-IND-V2 can host and control your Java J2ME application allowing you to develop and embed your
code directly inside, shortening time to market and reducing costs, minimizing the need for further
hardware components and making your M2M application easy to integrate.
RF 868MHz radio frequency WaveCard (Coronis) modules can be connected to the internal TC65i ASC1
port to create an RF network and concentrate in this GSM/GPRS unit. Remote units with low power RF
Wavesense are also available.
The Ethernet module can also be connected to the TC65i ASC0 and make ETH-GSM gateways. All these
features need to be JAVA programmed. If you would like a WIFI link instead of cable installation, it is
possible to have this if another module is connected to the ASC0. WIFI and Ethernet cannot be installed at
same time. By default, the Ethernet module is soldered to put CAT5 in the cable gland but, on request, it is
also possible to solder the RJ45 connector outside the box.
Other peripheral (check ordering information) are 4 relays 1C type capable to switch up to 8 Amp loads.
They’re connected to 4 GPIOs and can be controlled by AT commands or JAVA embedded programs. There
are another 2 configurable TTL/CMOS input/output
GPIOs and 2 optoisolated differential inputs/outputs.
With quad band 900/1800 MHz and 850/1900 MHz, your applications can be used all over the world.
The MTX-IND-V2 is RoHs, WEEE, FCC and CE compliant. It is manufactured with the ISO 9001 & IS0
14001 Quality certifications.
A full list of antennas, cables supplies and accessories are available.
The MTX-IND-V2 incorporates a Cinterion WM TC65i module.
Note! Some of the functions described inside this Technical Description are only possible when the SIM-
Card is inserted.
