3
Model
Pipe Clamping Range
In / mm
Shipping Dimensions
In // mm
Shipping Weight
Lbs. / Kg
QFC-12
1” – 2”
/
25 - 64
8-1/2 x 7 x 4
//
216 x 178 x 102
4
/
1.8
QFC-26
2 ” – 6"
/
50-150
13 x 10 x 5
//
330 x 254 x 127
10.6
/
4.8
QFC-512
5” – 12”
/
127 – 305
19 x 15 x 5
//
483 x 381 x 127
18.4
/
8.3
PIPE TO PIPE PIPE TO REDUCER PIPE TO ELBOW
3.0 -
INSTRUCTION OF USE
Step 1.
Remove the QUIK-Fit Clamp from the box
Step 2.
Check the clamp for functionality by rotating the T handle to make sure it covers its entire clamping range.
Step 3.
Rotate all
wing screw assemblies counterclockwise so just the end of the screw is exposed below the alignment bar.
Step 4.
Place the QUIK-Fit Clamp over the pipe or slip it over the end of the pipe and rotate the T handle assembly clockwise until it is
firmly clamped on the pipe.
Step 5.
Rotate all wingscrew assemblies clockwise until they contact the pipe.
Step 6.
Rotate the upper wingscrew assembly counterclockwise two (2) full turns.
Step 7.
Rotate the T handle assembly counterclockwise until the clamp is loose on the pipe.
WARNING:
When operating the clamp do not place fingers, hands or feet under the pipe or fitting. Failure to do so may
result in serious injury should the pipe or fitting fall.
WARNING: P
lacing hand or fingers between the screw block assembly and the middle block assembly when open the
clamp may result in serious injury.
WARNING:
Do not place hand or finger between the left or right frame assembly and the pipe. Failure to do so may
result in serious injury.
WARNING:
Do not place hand or finger between the left or right frame assembly and the pipe. Failure to do so may
result in serious injury.
