7
Page 33
Adjusting the cutting height for the rigid driving frame
The four casters must be adjusted uniformly.
3
2
4
1
3
Fig. 30: Caster on the mower
1.
Lift out the mower with the aid of the front power system, until there is an adequate distance
between the casters and the ground.
2.
Hold the caster firmly and remove the linch pin 1.
3.
Remove the spacer ring 2.
4.
Pull the caster downward slightly.
Pull out the required number of spacer rings 3 from the lower flattened surface 4, and fit
them on again on top. Or remove the required number of spacer rings 3 from above and
slide them back in at the flattened position 4.
5.
Re-secure the caster with the linch pin 1.
6.
Repeat instructions 1 - 6 on the other three casters.
7.
Each spacer ring changes the cutting height by 13 mm (0.5 inch)
