Aug.2019 Rev 1.0
www.mateksys.com
LAYOUT
Frequency Table (MHz)
Frequency Selection (Button)
IN: 6~36V DC (2~8S LiPo)
G: Ground
5V: on board 5V regulator, output 1A for camera and FC.
Vid: Video signal
Tlm: CMS control(Tramp protocol) via FC Uart_TX
PINIO: VTX power switch via FC PINIO
Aud: Audio(A6.5) input, on board microphone share this rail.
TX/RX: for flashing firmware and VTX firmware setting
36mm
28mm
36mm
20mm Φ3mm
30.5mm Φ3mm
28mm
Antenna
connector
MMCX
Press Button A to select the Group, Press B to select parameters in each Group.
When LED blinks, Group & parameter can be changed
New Frequency & Power will be saved if no button action within 5 seconds.
The VTX remains the current frequency until new setting is saved.
PIT mode: Press B to enter PIT mode(1mw output), Pit LED blinks
Press B again to quit PIT mode
*** E4(5645) & E8(5945) are disabled by default.
OSD
LED
1
2
3
4
5
6
7
8
BOSCAM A
A
5865
5845
5825
5805
5785
5765
5745
5725
BOSCAM B
B
5733
5752
5771
5790
5809
5828
5847
5866
BOSCAM E
E
5705
5685
5665
5645
5885
5905
5925
5945
FatShark
F
5740
5760
5780
5800
5820
5840
5860
5880
Raceband
R
5658
5695
5732
5769
5806
5843
5880
5917
