Made in Taiwan
to Matco specifications
DO NOT DISCARD – GIVE TO USER
Page 1
MT2421
MICRO 2" RANDOM
ORBIT SANDER
SPECIFICATIONS:
Pad Size: 2" & 3"
Spindle: 5/16"-24 (Female)
Orbit Diameter: 3mm
Free Speed: 7,000-16,000 RPM
Air Consumption: 3.1 CFM
Air Inlet: 1/4"
Motor: .4 HP
Pressure: 90psi
Exhaust: Side
Weight: 1.3 lbs.
Length: 4.3"
PRODUCT INFORMATION:
• Normal use of this product is likely to expose the user to
dust and/or microscopic particles containing chemicals
known to the State of California to cause cancer, birth
defects or other reproductive harm. Always wear
appropriate safety equipment and clothing when using this
product. Study, understand and follow all instructions
provided with this product. Failure to read and follow all
warnings and operating instructions may result in damages
and serious injury or death.
• Always wear ANSI approved goggles when using this
product. (Users and bystanders).
• Never use this tool for any application other than for
which it was designed.
• Only use accessories designed for this tool.
• Never alter or modify this tool in any way.
• Improper operation and/or maintenance of the tool,
modification of the tool, or use of the tool with accessories
not designed for it could result in serious injury or death.
• Always select the correct accessories of the correct size
and design for the job that you are attempting to perform.
• Always work in a clean, safe, well-lit, organized and
adequately equipped area.
• Do not begin repairs without assurance that vehicle is in
secure position, and will not move during repair.
WARNING
1 YEAR LIMITED WARRANTY
The manufacturer warrants this product to the original user against defective
material or workmanship for a period of 1 year from the date of purchase.
The manufacturer reserves the right to determine whether the part or
parts failed because of defective material, workmanship or other causes.
Failures caused by accident, alteration or misuse are not covered by this
warranty.
The manufacturer, at its discretion, will repair or replace product covered
under this warranty free of charge. Repairs or replacements of products covered
under this warranty are warranted for the remainder of the original warranty
period.
The manufacturer or its authorized service representatives must perform
all warranty repairs. Any repair to the product by unauthorized service
representatives voids this warranty. The rights under this warranty are
limited to the original user and may not be transferred to subsequent owners.
The warranty is in lieu of all other warranties, expressed or implied,
including warranties of merchantability and fitness for a particular purpose.
Some states do not allow the exclusion or limitations of incidental or
consequential damages, so the above limitations may not apply to you.
Authorized Matco Repair Centers:
United States
Matco Air Tool Repair SV
1330 Commerce Drive
Stow, OH 44224
(800) 433-7098
NMG Industrial WTRC
Attn: South Dock
2223 S. Wilson Street
Tempe, AZ 85282
Canada
H. T. Pneumatic Rebuilders Inc.
22 Goodmark Place
Units 7 & 8
Toronto, Ontario M9W6R2
WARNING
INTENDED USE OF THE TOOL
• Ultimate customization. Adjust running speed from
7,000-16,000 RPM and pad size from 2" to 3".
• Compact profile. Provides a fine DA finish at only 4.3
"
in length
• Unmatched power. .4 HP on tap for tough jobs.
1512179-14
Study, understand and follow all instructions provided
with this product. Read these instructions carefully before
installing, operating, servicing or repairing this tool. Keep
these instructions in a safe accessible place.
This sander is designed for sanding metal, plastic and
painted surfaces to strip paint for fine finishes. Do not use
this tool outside of the designed intent. Never modify the
tool for any other purpose or use.
