MCL18AG
3
rev. 09/09/09
MCL18AG 18V 4-1/2" Angle Grinder
2. Be aware that this tool is always in operating condition,
because it does not have to be plugged into an electrical outlet.
3. Always be sure you have firm footing.
4. Be sure no one is below when using the tool in high locations.
5. Hold the tool firmly and use both hands.
6. Keep hands and hair away from rotating parts.
7. Do not leave the tool running. Do not force tool to stay in the
“on” position. Operate the tool only when hand-held.
8. Do not touch the drill bit, impact socket, any adapter, or the
workpiece immediately after operation; they may be extremely
hot and could burn your skin.
9. Some material contains chemicals which may be toxic. Take
caution to prevent working dust inhalation and skin contact.
Follow material supplier safety data.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
OPERATING INSTRUCTION
Installing Or Removing Battery Pack
1. Your new battery pack is not fully charged. You may need to
charge before use.
2. Make sure the forward/reverse lever is in the neutral position
when installing or removing a battery.
3. To remove a battery, depress the front tab and pull the
battery forward and the tool in the opposite direction.
4. To install a battery align the tool with the battery, place the
front of the tool about halfway up the battery, push forward
until click is heard indicating full installment.
Charging The Battery Pack
1. Battery may not charge when it is above a certain preset
temperature limit. Allow temperature of battery to cool before
charging.
2. The charge process will take less than one hour.
3. After charging, unplug the charger from the power source
and stow away in a safe place.
To Assemble Grinding Discs:
1. Use stop spanner to hold spindle.
2. Screw on disc nut with shoulder side
facing tool. Tighten.
3. Attach grinding disc wheel.
4. Screw on other disc nut, shoulder side facing
tool. Secure tightly!
Tool Operation:
• Always use the recommended wheel guard
to prevent injury from broken grinding
wheel parts. If a guard has withstood
a wheel breakage, discontinue its use
and replace it with a new guard.
It may be damaged. Position the
guard between the grinding wheel and the
operator. Use barriers to protect others from
wheel fragments and grinding sparks.
• Always wear impact-resistant eye and face
protection when involved in the operation
of this tool. Even small projectiles can
injure eyes and cause blindness.
A grinding wheel that bursts can cause very serious injury.
Daily measure the air grinder speed with a tachometer to
make sure it's not greater than the RPM marked on the
grinding wheel. Never use a grinding wheel marked with
a speed lower than the air grinder speed.
• Before grinding, test grinding wheel by briefly running
the tool at full throttle. Be sure to use a barrier
(such as under a heavy work table) to stop any
possible broken wheel parts.
• Grinding draws high current and overheating may occur,
causing the circuit protection to shut the tool off.
Allow the tool and battery to cool before reuse.
