Step 9
Select UHF boom pictured below and clip the X type elements
onto 'U' shaped plastic insulators on the boom ensuring the
clips fit securely onto insulator on boom.
Then attach the UHF Dipole ensuring that
the X dipole is positioned towards the front
of the Antenna. See diagrams.
Step 10
Assemble UHF
Boom to VHF boom
as per diagram
using 5mm screw
and wing nut
provided.
Step 12
Then attach corner reflector
using the two screws
and wing nuts provided
as per diagram.
Step 13
Attach antenna to mast and point to transmitter as per
diagram. Rotate antenna to achieve best results. Attach cable
to cable tie near u-bolt and attach cable to mast with UV
grade insulation tape or UV grade
cable ties to support cable weight and avoid damage to
connection from wind whipping cable from side to side.
When using the antenna in Canberra, Condobolin,
Taree, Bundaberg, Shepparton and where
UHF is horizontally polarised and VHF is
vertically polarised, turn VHF section so
the elements are vertical .
You will then need to use a stand off
boom mount ( 11MM-SM1-15 ) NOT
INCLUDED to attach antenna to mast.
Attach theSM1-15 to the mast, then attach
the antenna to the SM1-15.
For any technical enquiries, please call Matchmaster TV Reception Systems on
Toll Free Aust: 1800-AERIAL (1800-237425) or Toll Free NZ: 0800-AERIAL (0800-237425)
Step 11
Attach U bolt and mast clamp as per diagram. Then attach the
other end of the short cable to the balun on the VHF dipole.
Attach the short cable and the antenna downlead to the boom
using the cable tie provided. This is to ensure cable
does not move in the wind.
To Transmitter
