Matan Barak Скачать руководство пользователя страница 3

Страница: 3 / 8

Pull these 5 clips
and remove the PLC
unit from its rails.

The Block PLC – close-up view

Replacing the Machine PLC Hardware

1. Shut down the printer.

2. Put switch into STOP mode.

3. Disconnect the two green connectors.

4. Disconnect the D

ATA

OMMUNICATION

ABLE

from underneath

the module DVP-14SS.

5. Disconnect the white connector(s) from underneath the PLC

you wish to replace.

6. Remove the PLC from the printer by pulling the white clips, and

removing it from the rail.

If you are changing only one module, make sure that you firmly

connect the module's connectors, as shown above.

7. Make sure that the new PLC’s switch is set to STOP.

8. Attach the new PLC to the rail by lifting the white clip on top of

the PLC and the one that is located underneath. Make sure
that the PLC is securely connected to the one next to it.

10100142 - A

Page 3 of 8

Содержание Barak

Страница 1: ...Replacing the PLCs Technical Note 10100142 Rev A 10100142 A Matan Digital Printers Ltd Page 1 of 8 ...

Страница 5: ... Digital Printers Ltd Page 5 of 8 For Machine_PLC the STATION ADDRESS should be set to 2 as shown below Change this field from COM13 to COM8 5 Click UPDATE for PLC updating by the correct file The following message appears 6 Click YES to confirm The UPDATE starts When the UPDATE has finished the following message appears ...

Страница 6: ... to close the COMMUNICATION dialog box 10 Choose another DVZ file by clicking OPEN again or click EXIT to close the DVP_Tool Machine PLC is located at the right side of the printer next to the UV power supplies and the main electric panel 10100142 A Matan Digital Printers Ltd Page 6 of 8 ...

Страница 7: ...rinter S N Faulty Part Name Details of faulty part Remarks Signed Name Position in Company Date The Printer s Serial Number is displayed on the label located at the rear of the printer near the left end of the rollers as shown below 10100142 A Matan Digital Printers Ltd Page 7 of 8 ...