Masterzen PRM 180, Инструкция по эксплуатации

Страница: 35 / 50

User Manual
Συντηρητές Κρασιών XPR
Your wine cellar is designed with “Auto-cycle” defrost system. During “Off-cycle” the
refrigerated surfaces of the wine cellar defrost automatically. Defrost water from the wine
cellar storage compartment drains automatically and part of it goes into a drainage container,
which is located at the back of the wine cellar next to the compressor. The heat is
transferred from the compressor and evaporates any condensation that has collected in the
pan. Part of the remaining water is collected within the wine cellar for humidity purposes.
This system enables the creation of the correct humidity level inside your wine cellar
required by the natural cork to maintain a long lasting seal.
Notes: The water collected by condensation, is therefore recycled. Under extremely dry
environmental conditions, you may have to add some water into the water container
provided with your wine cellar
.
All units are equipped with a double glazed glass door that has a third internal acrylic layer
to minimize condensation on the glass door.
The wine cellar is not totally sealed; fresh air admission is permitted through the drainpipe.
Air is circulated through the cellar by means of a fan/fans and the hollow shelves.
Notes: During the refrigerating cycle, heat is given off and disperses through the external
surfaces of the wine cellar. Avoid touching the surfaces during those cycles.
ADJUSTABLE WOODEN SHELVES
Adjusting & removing the shelves
For easy access to the storage content, you must pull the shelves approximately 1/3 of its
depth out of the rail compartment. These wine cabinets, however, are designed with a
notch on each side of the shelf tracks to prevent bottles from falling.
When removing any of these shelves out of the rail compartment, tilt the shelf as per the
diagram and simply pull out, or push in the shelf until it sits on the support brackets
securely.
Shelf installation and taking instruction:
Common wooden shelf:
Shelf taking: According to below instruction drawing to press one side of shelf limit pin①,
extract and remove the shelf from the other side of support bracket②, then take off the
shelf following the arrow mark ③.
Shelf installation will be opposite with shelf taking.