2
June 2008 / MasterBus-Inverter Interface / EN
1 GENERAL
INFORMATION
1.1
Use of this manual
This manual serves as a guideline for the safe and
effective operation of the Inverter Interface.
Keep this manual at a secure place!
1.2
Guarantee specifications
Mastervolt guarantees that this product was built
according to the legally applicable standards and
stipulations. If you fail to act in accordance with the
regulations, instructions and stipulations in this
user’s manual, damage can occur and/or the
product will not fulfil the specifications. This may
mean that the guarantee will become null and void.
IMPORTANT: Additional warranty agreements, like
“Mastervolt system warranty” may contain
restrictions which forbid resetting of historical data
The standard guarantee period is two years after
date of purchase.
1.3 Liability
Mastervolt can accept no liability for:
x
consequential damage due to use of the Inverter
Interface;
x
possible errors in the manuals and the results
thereof;
x
Use that is inconsistent with the purpose of the
product.
CAUTION!
Never remove the identification label.
2 OPERATION
The Inverter Interface operation is entirely MasterBus based. For information about MasterBus and the MasterBus
event structure, see
www.mastervolt.com
.
The table below shows the Inverter Interface MasterBus functions:
Monitoring
Description
Factory settings
Range
State
Interface can be switched On or Stand by
-
Stand by/ On/
Alarm*
Inverter
Change the state of the interface
Stand by
Stand by/ On
Configuration
Description
Factory settings
Range
Language
Set the Inverter Interface menu language
English
See specifications
Device name
Any name you wish with 12 characters max
INT inverter
12 characters max
Event 1 Source
Select an event in the Inverter interface
Event list to serve as Source.
Disabled Disabled,
State,
Failure mode
Event 1 Target
Select a device in your system to serve as a
Target.
System dependent
System dependent
Event 1 Command
Select a command in the Target command
list.
Target dependent
Target dependent
Event 1 Data
Select the way the Command should act on
the Source
See MasterBus
information
See MasterBus
information
Event 2 - 9
See Event 1
* The alarm state cannot be selected. When the inverter is in alarm, it sends out a signal to the interface.
Described above are the events with the interface as Source. The Inverter Interface can serve as Target too.
It can be switched On and Standby (State) in the configuration menu of another MasterBus device:
Configuration
Description
Factory settings
Range
Device Event
Command
Select a command in the Inverter interface
Command list
Disabled Disabled,
State
