Installation Instructions
3
Installation of ShadeMaker Bimini Plus Top:
Step 1: Attach the Mesh Front Section to the Front
Windshield Pillar
Put on safety glasses.
After removing your hard top or soft top, locate the
front section of your Bimini top Plus and drape the
Front mesh fabric over the top of your Jeep with the flat
straight edge facing forward.
Wrap the long front straps around the Sport Bar, throu-
gh the gap between the front roll bar and the wind-
shield and back to the buckle on the strap. See FIGs 1
& 2. Note: To make this “threading process” easier, run
your fingers over the end of the strap to keep it from
curling. Repeat on the other side of the vehicle.
Tighten each side strap making sure the top is cente-
red on the vehicle and that the front portion is pulled
forward. These straps should be very tight to keep the
mesh from moving rearward. See FIG 3.
Step 2: Attach Front Section to Rear B Pillar
Locate the two rear corner straps and wrap around the
“B” pillar. Thread the straps through the buckle and
secure making sure the top is centered on the vehicle.
See FIGs 4 & 5.
Repeat on the other side of the vehicle.
Once the rear corner straps are secure and the top
is centered, locate the two rear hook and loop center
straps attached to the rear of the top (See FIG’s 6 &
6A).
Using a T25 Torx bit (found in your factory on-board
Torx tool kit) and driver, remove the screw on the sound
bar header and install the webbing using the same
screw (Figs 7 & 8). Thread the Hook and loop strap
on
the rear of the mesh top through the rectangle loop and
tighten (Fig 9 & 10).
Repeat this procedure for
both
of the screw/strap
locations.
Front Mesh Bimini Top Installation is now
complete.
See following pages for installation of the
Rear Section.
FIG 6A