Mastergrip 480410, Инструкция по эксплуатации

Страница: 20 / 24

20
Attaching Tabletop Inserts to the Router Table
Table Top Inserts to the Router Table
This router table comes with three tabletop inserts in the following hole sizes:
• 1-1/4" (3,18cm) diameter, for use with router bits with diameters up to 1-1/8" (2,86cm)
• 1-7/8" (4,76cm) diameter, for use with router bits with diameters up to 1-3/4" (4,45cm)
• 2-1/8" (5,39cm) diameter, for use with router bits with diameters up to 2" (5,08cm)
WARNING:
A 2-3/4" (6,98cm) diameter router bit is the LARGEST router bit that can be used on this
router table. Router must be turned OFF and UNPLUGGED.
1. Select the tabletop insert that accommodates the
router bit to be used.
2. Push the insert into the large hole in the top of
the router table.
3. Press down the tabs on the insert until they
snap into place.
4. To remove, place a finger in the insert hole and
gently pull up until the tabs disengage.
WARNING:
DO NOT attempt to remove tabletop insert from
the tabletop unless router bit has been removed
from the router.
Routing Using the Fence:
1. Set the speed control to the required speed (if you are not sure of the correct speed, experiment until you
find a speed that creates the desired cut easily).
2. Set the depth of the cut (1/4" (6,35mm) to 3/8" (9,53mm) is absolute maximum for one pass).
3. Loosen the plunge lock and press the main body up to the stop. Lock the body in position.
4. Check that the line of the cut is clear. Make sure no fingers, foreign objects or power cables are in the way.
WARNING:
Failure to keep your fingers, hands and other body parts out of the way of the router bit
can result in serious bodily injury.
5. Allow the motor to reach full speed and move the cutter into the work piece.
6. Hold the work piece firmly. Be prepared for a small kick as the cutter engages the wood. Move the wood
against the direction of rotation, pushing or pulling depending on the orientation of the work piece.
Continue moving the work piece along the line of the cut until you reach the end of the wood.
WARNING:
The overhead guard must be down in the operating position when using the miter gauge.
Routing Using the Fence