MasterForce HAMMERHEAD, Руководство оператора

Страница: 11 / 16

page 11
CHARGING A HOT BATTERY PACK
If the battery pack is above the normal
temperature range, the red LED will
illuminate and the green LED will be off.
When the battery pack cools down to
approximately 104°F (40°C), the charger will
automatically begin charging.
CHARGING A COLD BATTERY PACK
If the battery pack is below the normal temperature
range, the red LED will illuminate and the green
LED will be off. When the battery warms to a
temperature of more than 50°F (10°C), the charger
will automatically begin charging.
DEFECTIVE BATTERY
If the charger detects a problem, the red LED will
begin flashing and the green LED will be off.
1. If registering as defective, remove and
reinsert the battery pack in the charger. If
the LED status reads “defective” a second
time, try charging a different battery pack.
2. If a different battery pack charges
normally, dispose of the defective battery
pack (see Maintenance section).
3. If a different battery pack also indicates
“defective,” the charger may be defective.
BATTERY CHARGING
If the battery pack is within normal temperature
range, the green LED will begin flashing and
the red LED will be off. The battery pack will
reach a full charge in 30 minutes.
BATTERY FULL
When fully charged, the green LED Light on
the charger will be on and the red LED light
will be off.
NOTE: The battery pack will fully charge,
but will not overcharge, if left on the
charger.
NOTE: The charger may warm with several
continuous charge cycles. This is part of the
normal operation of the charger. Charge in a
well ventilated area.
TO ATTACH BATTERY PACK (Fig. 4)
CAUTION:
To avoid the
possibility of accidental starting, always
take care not to activate the trigger switch
when you are attaching the battery pack or
performing others adjsutments to the tool.
1. Align the raised portion on the battery pack
with the grooves on the bottom of the auto
hammer, then attach the battery pack to the
auto hammer as shown in Fig. 4.
2. Make sure that the latch on the battery pack
snaps into place and the battery pack is
secured to tool before beginning operation.
CAUTION:
When placing the
battery pack in the tool, be sure that the
raised ribs on battery pack aligns with
the groove on the auto hammer and the
latches snap into place properly. Improper
assembly of the battery pack can cause
damage to internal components.
TO DETACH BATTERY PACK (Fig. 4)
1. Depress the battery release button
located on the both sides of the battery
pack to release battery pack.
2. Pull battery pack out and remove it from
the tool.
ATT
ACH
DET
ACH
FIG. 4