MasterForce 241-0465, Руководство оператора

Страница: 11 / 20

Page 10
ASSEMBLY
INSTALLING AND REMOVING
THE BELT CLIP (FIG. 3)
To install the belt clip:
1. Remove the battery from the tool.
2. Align the rib of the clip with the hole on
the base of the hammer drill.
3. Insert the screw (included) and tighten
the screw securely with a screwdriver
(not included). The belt clip can be
positioned on either side of the tool.
To remove the belt clip:
1. Remove the battery from the tool.
2. Use a screwdriver to loosen the screw
that attaches the belt clip to the hammer
drill.
3. Remove the screw and the belt clip.
FIG. 3
Belt clip
Screw
INSTALLING AND REMOVING
THE BIT HOLDER (FIG. 4)
To install the bit holder:
1. Remove the battery from the tool.
2. Align the rib of the bit holder with the
hole in the base of the hammer drill.
3. Insert the screw (included) and tighten
the screw securely with a screwdriver
(not included). The bit holder can be
positioned on either side of the tool.
To remove the bit holder:
1. Remove the battery from the tool.
2. Use a screwdriver to loosen the screw
that attaches the bit holder to the
hammer drill.
3. Remove the screw and the bit holder.
FIG. 4
Bit holder
Screw
INSTALLING AND REMOVING
THE SIDE HANDLE (FIG. 5)
WARNING:
To reduce the risk
of injury, always use a side handle when
using this tool. Always hold it securely.
Ensure that side handle is tightened
securely before each use.
To install the side handle:
1. Remove the battery from the tool.
2. Loosen the side handle grip until the
hooks are far enough apart to fit into the
slots on the gear-case ring.
3. Position the side handle on the left or
the right side of the tool.
4. Slide the hooks into the slots as far as
the hooks will go.
5. Tighten the side handle grip until it is
secure.
To remove the side handle:
1. Remove the battery from the tool.
2. Loosen the side handle grip until the
side handle can be removed.
FIG. 5
Slot
Hook
Loosen
Tighten