MasterCraft 54-8333-2, Руководство пользователя

Страница: 15 / 22

15
ON/OFF SWITCH
This tool has dual purpose ON/OFF switch
that is designed to prevent accidental
starting of the tool. It also automatically
turns the tool OFF then the switch is not
held in the ON position.
1. Press the center of the switch (1)
inward (see Fig. 8).
2. While holding the center of the switch
inward, slide the switch button (2)
forward until the tool starts.
3. To stop the tool, release the switch
button. It will automatically turn the tool
OFF.
CUTTING (without edge guide)
WARNING: Always use two hands
on the tool when cutting. This will make
operation of the tool easier and promote
maximum safety.
1. Install appropriate cutting blade in the
tool.
2. Adjust cutting depth as outlined on
Page 13.
3. Plug the tool cord into the power
source.
NOTE:
The green “power on” light (1)
on the right hand side of the tool will
illuminate when power is “live” (see
Fig. 9).
4. Place leading edge of the blade guard
(2) on the workpiece to be cut (see
Fig. 10).
5. Grasp the tool with two hands. Place
your right hand on the body of the tool
(3) being careful not to cover the motor
vents (4). Place your left hand on the
forward part of the tool (5) so your
thumb can operate the blade guard
release button (6).
6. Line up front cut line indicator (7) with
the cutting line marked on the
workpiece (8).
NOTE: Do not place the blade guard
too far forward on the workpiece. This
is important to avoid the blade
touching the workpiece when the blade
guard is raised to expose the blade as
outlined in instruction # 8.
ASSEMBLY AND OPERATION
– MULTI-CUTTER
!
Fig. 8
Fig. 9