headline bars
continuation tabs
notes
warnings
model no. 043-8409-0 | contact us 1-800-689-9928
8
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
OPERA
TING INSTRUCTIONS
PREPARATION
ASSEMBLY INSTRUCTIONS
TURNING HEATER ON
GROUNDING
PIN
GROUNDING
PIN
COVER OF GROUNDED
OUTLET BOX
Place the heater on a firm, level
surface, plug into a grounded,
120 V (60 Hz) power outlet and
turn the power switch on the front
of the unit. Only operate heater in
upright position.
Before initial use some assembly is
required. With a cross-head screwdriver,
attach handle to heater body using screws
provided as shown in the illustration.
To start the heater, turn the On/Off
power level/fan dial from the OFF
position to the 1300 or 1500 W
setting. Then rotate the thermostat
control clockwise to the HIGH
thermostat position as described below.
During the heaters initial use, you may
experience a slight odour or smoking.
This is the result of the heating element
lubrication “burning off”. This is normal
and will go away after a few minutes
of use.
1
WARNING!
This heater has a voltage rating of 120 V. The cord has a plug as shown. The three-blade grounding plug extending
from the adaptor must be connected to a permanent ground such as a properly-grounded outlet box. The adaptor
should not be used if a three-slot grounded receptacle is available.
DO NOT DEFEAT THE SAFETY PURPOSE OF THE GROUNDED PLUG.
It is normal for the power cord to feel warm to the touch; however, a loose fit between the outlet and the plug may
cause overheating of the plug. If the plug is loose, do not use this outlet. Rather, try inserting the plug into a different
outlet. Contact a qualified electrician to inspect the original outlet.
FPO
model no. 043-8409-0 | contact us 1-800-689-9928