MasterCraft 14", Инструкция по безопасности и эксплуатации, Страница: 6 / 8

Full Bag Indicator
Your vacuum has an indicator light which
will flash
RED
if the bag is full or airflow is
obstructed. When the indicator light is on,
open the door and check the bag.
If the bag is full, replace it. If is not full
and the light is
ON
, there is an obstruction
in the system. Check the hose and wand
first. If they are clear, check the inlet in the
power brush base by removing wand from
the inlet and viewing the air path from the
inlet to the brush. If this area is clear,
remove the bag and check deflector port in
the top of vacuum housing.
Thermal Overload On
Vacuum Motor
This vacuum is equipped with a sensor that
shuts off the vacuum motor if the internal
temperature is too high. This is normally
created by an obstruction in the system
cutting off the air flow.
If the motor stops during use:
A.
Turn
OFF
main switch.
B.
Unplug vacuum from receptacle.
C.
Inspect and remove obstruction.
The motor will automatically restart when
the switch
ON
and when has motor cooled-
sufficiently.
Electronic Power Alert
This vacuum has an electronic control that
alerts the operator to problems in the
brush section.
! #
Clear operating
# #
Belt out/Broken
# !
Brush Blocked
Green Light
Lower section operating properly.
Red Light
Brush roll obstructed.
Red & Green Lights ON
Drive belt broken.
The operator must constantly monitor the
alert lights for proper performance and
correct problems immediately.
Before Each Use
Check to ensure that the filter bag is in
place and that it is not full. Replace if nec-
essary. Inspect the brush area and remove
any threads, strings, or debris that may be
wrapped around the brush.
CAUTION:
Belt replacement or other
repairs to the lower section should only be
performed by an authorized service center.
S
AFE
-G
UARD
F
EATURES
Always turn OFF the main switch and unplug the cord
before performing any maintenance
P
AGE
6
1.
Plug the power cord into a 115 volt, 60
cycle receptacle.
2.
Adjust the brush height knob to suit the
carpet thickness you are working on. (See
Fig D)
NOTE:
On the 18" upright, you may need
to set the height adjustment at (3) for low
pile carpet during the (3 Months) break-in
period.
3.
Turn the main power rocker switch to
"ON"
. The vacuum motor will start (Fig E).
4.
Depress the
YELLOW
foot pedal and
lower the handle to the operating position.
When the handle is lowered, the brush
motor will start. Use normal vacuuming
procedures. (Fig F)
O
PERATION
I
NSTRUCTIONS
C
AUTION
: