model no. 062-3428-8 | contact us 1-800-689-9928
10
INSTALLATION INSTRUCTIONS
The well motor pump must be installed in a stationary position with a fixed pipeline
and a steady water supply.
Please Note!
1. Remove the screw from the front of the unit to connect the power to the heater.
2. The pump must be installed with an automatic float switch (not included) to
prevent running dry.
Power Supply
1. The pump is equipped with a shock-proof plug according to regulations. The
pump is designed to be connected to 120 V~, 60 Hz safety socket.
2. Make sure that the socket is sufficiently secured and is in excellent condition.
3. When the plug is inserted into the socket the pump will be on standby.
Installation Considerations
This pump is designed for use as a well pump.
INSTALLATION INSTRUCTIONS
NOTE:
a. ONLY pump clean water.
b. Additional components (such as valves and pipes) may be required for installation, but not included.
c. Installation requires skilled workmanship and compliance with local building codes. If you are not
confident in your ability to properly and safely install this pump, have a qualified technician perform
the installation.
d. The water to be pumped must be clean and must be free of sand and grit which will damage the
pump and void the warranty.
WARNING:
If the power cord or plug is damaged, do not use the pump. The power cord or plug may only be repaired
by a certified electrician.
WARNING!
TO PREVENT SERIOUS INJURY FROM ELECTRIC SHOCK:
• Install indoors or in weather-proof well house only.
• This pump is non-submersible.
• Do not plug in the power cord when wet or standing on damp or wet ground.
• Do not plug in the power cord until instructed to do so.