model no. 062-3422-0 | contact us 1-800-689-9928
6
SAFETY
ADDITIONAL SAFETY PRECAUTIONS
1. Know the pump applications, limitations, and potential hazards.
2. Make certain the electrical power source is adequate for the requirements of
the pump.
3. ALWAYS disconnect the power to the pump and drain all water from the
system before servicing.
4. Secure the pump on a solid base to prevent the pump from tipping over and
possibly falling into the water.
5. Secure the discharge hose before starting the pump. Pump torque may cause
an unsecured discharge hose to “whip”, possibly causing personal injury
and/or property damage.
6. Before using the pump, check hose for holes or excess wear, which could
cause leaks, and be sure hose is not kinked or making sharp angles. A straight
hose allows the pump to move the greatest amount of water quickly.
7. Check that all hose connections are tight to minimize leaks. Ensure all hose
washers are in place.
8. Connect the pump DIRECTLY to a grounded, GFCI outlet.
9. Extension cords may not deliver sufficient voltage to the pump motor. If an
extension cord must be used, use no more than a 25' (7.6 m), 3-prong,
16 AWG, outdoor-grade cord.
10. Make certain the electrical circuit to the pump is protected by a 5 A minimum
(15 A maximum) fuse or circuit breaker.
11. Periodically inspect pump and system components to be sure pump inlets are
free of mud, sand, and debris. DISCONNECT PUMP FROM THE POWER SUPPLY
BEFORE INSPECTING.
12. Wear safety glasses at all times when working with pumps.
13. Follow all electrical and safety codes, particularly the National Electrical Code
(NEC) or the Canadian Electrical Code (CEC), and in the workplace, the
Occupational Safety and Health Act (OSHA) or the Canadian Centre for
Occupational Health and Safety (CCOHS).
14. This unit is designed only for use on 115 V (single phase), 60 Hz, and is
equipped with an approved 3-conductor cord and 3-prong grounded plug. DO
NOT REMOVE THE GROUND PIN UNDER ANY CIRCUMSTANCES. The 3-prong
plug must be directly inserted into a properly installed and grounded 3-prong,
grounding-type receptacle. Do not use pump with a 2-prong wall outlet.
Replace the 2-prong outlet with a properly grounded 3-prong receptacle (a
GFCI outlet) installed in accordance with the NEC or CEC and local codes and
ordinances. All wiring should be performed by a qualified electrician.
15. Protect the electrical cord from sharp objects, hot surfaces, oil, and chemicals.