MasterCraft 060-1349-2, Инструкция по эксплуатации

Страница: 8 / 24

headline bars
continuation tabs
notes
warnings
8
model no. 060-1349-2 | contact us 1-800-689-9928
V ..................... Volts
A ..................... Amperes
Hz ................... Hertz
W .................... Watts
min ................. Minutes
................. Alternating current
or d.c..... Direct current
n
0
.................... No-load speed
................ Class II Construction
RPM ................ Revolutions per minute
................ WARNING – To reduce the risk of injury, user must read instruction manual.
......... .. ..... WARNING – To reduce the risk of injury, always wear eye protection.
................ WARNING – To reduce the risk of injury, always wear ear protection.
........ The logo of UL certification
WARNING!
To reduce the risk of electric shock or damage to the charger and battery, use only the
Mastercraft
®
batteries and chargers listed.
BATTERY PACKS CHARGERS
054-3124-0, 054-7553-4, 054-7557-6 054-3126-6, 054-7559-2
• When replacing the cutting line, use no more than 0.08” (2.0 mm) nylon line; using
heavier lines than recommended by the manufacturer increases the load on the motor and
reduces its operating speed. This results in overheating and damage to the trimmer.
• To reduce the risk of serious injury, never use wire or metal-reinforced line or other
material in place of the nylon cutting lines. Pieces of wire could break off and be thrown at
high speed toward the operator or bystanders.
• Replace a cracked, damaged or worn-out cutting head immediately, even if damage is
limited to superficial cracks. Such attachments may shatter at high speed and cause serious
or fatal injury.
• For best results, your battery and tool should be stored, charged and used in a location where
the temperature is more than 5°C (41°F) but less than 40°C (104°F) .
Do not store outside or in
vehicles.
SAFETY GUIDELINES