17
WARNING!
Potential hazard that could result in serious injury or
loss of life.
• Replace or repair damaged parts or accessories before
using the Air-powered Impact Wrench.
• Use only recommended and properly rated replacement
parts. Non-authorized parts may be dangerous and will
void the warranty.
• Disconnect the Air-powered Impact Wrench from the
air supply before changing accessories, servicing, or
performing maintenance. Failure to comply could lead
to serious injury or loss of life.
CAUTION!
Potential hazard that may result in moderate injury or
damage to equipment.
• Never use damaged parts.
• Do not use an excessively worn tool. Failure to comply
may result in moderate injury or damage to equipment.
16
model no. 058-9803-0 | contact us 1-800-689-9928
None
X
X
X
See below
X
MAINTENANCE
REQUIRED
TOOLS OR
MATERIALS
REQUIRED
DESCRIPTION
Each Use or
every 2 Hrs
MAXIMUM SERVICE INTERVAL
Monthly
As
Needed
General inspection-
free movement
In-depth inspection
Replace worn or
broken parts
Lubrication
Trigger, spring,
safety mechanism
Worn or broken
parts
Pneumatic tool
oil
Maintenance
• Lubrication: If the Air-powered Impact
Wrench and the compressor are not equipped
with an in-line lubrication system, place up
to 6 drops of pneumatic tool oil into the air
inlet before each work day or after every 2
hours of continuous use, depending on the
characteristics of the workpiece and type
of fasteners used.
• Air-operated tools must be inspected periodically and worn or broken parts must be
replaced to ensure that the tools are operating safely and efficiently.
• Inspect and replace worn or damaged O-rings, seals, etc. Tighten all screws and caps
frequently in order to help prevent personal injury.
• Keep the magazine of the tool clean and free of any dirt or abrasive particles.
X
• The tool should be properly lubricated by keeping the in-line lubricator filled and correctly
adjusted. Without proper lubrication, the tool will not work effectively and parts will wear
prematurely.
• Inspect the tool periodically and replace worn or broken parts in order to keep tools operating
safely and efficiently.
• Tighten all screws and caps frequently in order to prevent personal injury.
• Inspect the trigger, the spring, and safety mechanism for free movement on a regular basis in
order to ensure that the safety system is fully functional. Verify that no parts are loose or
missing.
Storage
• When the tool is not in use, disconnect it from the air supply, clean, and store it in a safe, dry,
childproof location.
• When the tool is stored for longer period of time, apply an ample amount of lubricating oil
before storing.
• Run the tool for approximately 30 seconds after lubricating, in order to ensure that the
lubrication is uniformly distributed throughout the tool. Store the tool in a clean and dry
environment.
