TOOLS NEEDED FOR ASSEMBLY
Star-head screwdriver
WARNING!
If any parts are damaged or missing do not operate this tool until the parts are replaced. Use of
this product with damaged or missing parts could result in serious personal injury.
•
Do not attempt to modify this tool or create accessories not recommended for use with this tool.
Any such alteration or modification is misuse and could result in a hazardous condition leading
to possible serious personal injury.
•
Do not connect to power supply until assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
•
Risk of injury! Always pull out the mains plug (disconnect the product from its power supply)
before commencing work on the product.
17
ASSEMBLY INSTRUCTIONS
16
ASSEMBLY INSTRUCTIONS
UNPACKING
Do not use this product if any parts of the package contents are already assembled to your product when you
unpack it. Package contents are not assembled to the product by the manufacturer and require customer
installation. Use of a product that may have been improperly assembled could result in serious personal injury.
•
Inspect the tool carefully to make sure no breakage or damage occurred during shipping.
•
Do not discard the packing material until you have carefully inspected and satisfactorily operated the tool.
•
The saw is factory set for accurate cutting. After assembling it, check for accuracy. If shipping has
influenced the settings, refer to specific procedures explained in this manual.
•
If any parts are damaged or missing, please call: 1-800-689-9928 for assistance.
Fig. 1
Fig. 2
Fig. 3
WARNING!
Be sure to observe the rotational direction of the cutting disc when fitting! Be sure to observe the
free-wheeling of the cutting disc when fitting!
FITTING THE CUTTING DISC (Fig. 1-4)
•
Unplug the tile cutter from the mains supply.
•
Raise the 45° Vertical fence (1) approx. 45° and
remove.
•
Loosen cross-screws (2) with the Star-head screwdriver
(not supplied) and pull off lower protective guard (3).
•
Attach the straight wrench (4) (supplied) to the hex
nut (5).
•
Lock motor shaft (6) to prevent turning using angled
wrench (7) (supplied).
•
Turn the hex nut (5) anti-clockwise.
•
Remove the hex nut (5) and outer flange (8).
•
Place cutting disc (9) on inner flange (10).
•
Attach the outer flange (8), the double “D” flats on the
outer flange align with flats on motor shaft.
•
Screw hex nut (5) onto motor shaft (6) clockwise.
•
Attach the straight wrench (4) to the hex nut (5).
•
Lock motor shaft (6) to prevent turning using angle
wrench (7).
•
Tighten hex nut (5) clockwise using straight wrench (4).
•
Re-attach the lower protective guard (3) and tighten
cross-screws (2).
CAUTION!
When fitting make sure that the cutting disc is placed correctly on the inner flange. The inner
flange can be moved freely on the motor shaft and has a section for holding the internal hole
of the cutting disc. The hole of the outer flange is not round and is used for the interlocking
connection with the motor shaft.
model no. 055-6778-4 | contact us 1-800-689-9928
NO.
Description
Qty.
Illustration
Wrenches
9
2
2
3
8
1
2
5
4
5
7
6
6
Fig. 4
9
8
5
6
10
