14
15
model no. 055-6740-2 | contact us 1-800-689-9928
ON/OFF switch
(Fig. 11)
press the switch
(1)
to the
ON
(i) position in order to start
the wet tile saw. press the switch to the
OFF
(o) position in
order to stop the wet tile saw.
Reset button
in the event of an overload, the wet tile saw is equipped
with a reset button. if the tile saw experiences an overload:
1. Turn the power switch to the
OFF
position. Unplug
the power cord from the power source if you have to
remove a workpiece from the tile saw.
2. Allow the tile saw to cool for a few minutes.
3. Plug in the power cord.
4. Press the reset button
(2)
.
5. Turn the power switch to the
ON
position.
Cutting tile
(Fig. 12)
1. Fill the water compartment with water. Verify that the water level is above the metal rack.
2. Pull the handle
(4)
of the blade assembly toward the operator so that the blade is not above the worktable
(1)
.
3. Place a tile on the worktable so that it is resting
against the ruler
(2)
at the rear of the worktable.
4. Use the ruler to align the tile with the blade.
5. Secure the tile using the clamp assembly
(3)
and/or
mitre gauge.
6. Verify that the blade is not touching the tile, and then
turn the saw on.
7. When the blade reaches full speed, push the handle
(4)
in order to move the blade assembly forward and
cut the tile.
ASSEMBL
Y INSTRUCTIONS
OPERA
TING INSTRUCTIONS
Adding water
(Fig. 9 and 10)
1. Verify that the drain plug
(1)
is in the drain opening on
the tray.
2. Add water until the water covers the metal rack that
supports the blade/worktable assembly. Verify that the
water pump is completely submerged.
3. Add water as needed while the tile saw is in use.
Draining water
(Fig. 10)
1.
Turn OFF
the wet tile saw and unplug it from the
power source.
2. Place a container under the drain plug opening, or
place the tile saw over a sink or drain.
3. Turn the drain plug
(1)
and pull on it in order to
remove it from the tray. Allow the water to drain out of
the opening in the tray.
1
Fig. 10
Fig. 9
CAUTION!
Verify that the metal bars in the water tray are covered with water. the water pump may be
damaged if it is not completely submerged while the tile saw is in use.
NOTE:
if necessary, the blade assembly and worktable can be removed from the tray. See maintenance section for
detailed instructions.
NOTE:
for wet cutting, verify that the water filter is properly installed and that the tray is filled with water. See
Adding water
section.
2
1
Fig. 11
1
2
3
4
