NOTE:
One or two of the feed handles may be removed if an unusually-shaped workpiece interferes with handle
rotation.
WARNING!
To reduce the risk of injury, never connect plug to power source outlet until all assembly steps
are completed.
Fig. 2
model no. 055-5530-8 | contact us 1-800-689-9928
21
ASSEMBLY INSTRUCTIONS
20
ASSEMBLY INSTRUCTIONS
BASE TO COLUMN (Fig. 2)
•
Set the base (1) on the floor.
•
Place the column tube (2) on the base (1), align the
column support holes with the base holes.
•
Install a bolt M8 x 25 (3), a flat wahser M8 (4) and a
spring washer M8 (5) in each column support hole and
tighten with the wrench.
TABLE TO COLUMN (Fig. 3–5)
•
Insert the rack (1) into the geared groove of the table
support (2). Make sure the worm shaft (3) on the
inside of the table support is engaged with the teeth of
the rack. The table support should sit at the centre of
the rack.
•
Slide the table support and rack assembly (1, 2, 3)
down together onto the column. Insert the bottom edge
of the rack into the lip (4) of the column support. HOLD
IN THIS POSITION until the next step is completed.
•
Place the collar (5) bevel side down over the rack.
Tighten the set screw (6) with the 3 mm Allen wrench
to hold the rack in position.
Make sure there is enough clearance to allow the table to
rotate around the column. The collar must sit loosely over
the rack and not angled on the column. To avoid column or
collar damage, only tighten the set screw enough to keep
collar in place (Fig. 4).
DRILL PRESS HEAD TO COLUMN (Fig. 6)
•
Lift the drill press head assembly (1) carefully and place
the mounting hole of the drill press head onto the top
of the column (2). Make sure the head is seated
properly on the column.
•
Align the direction of the drill press head with the
direction of the base and the table.
•
Tighten the two set screws (3) using an Allen wrench.
FEED HANDLES (Fig. 7)
•
Thread the three feed handle rods (1) into the holes on
the feed hub (2).
•
Hand tighten.
Fig. 6
Fig. 7
Fig. 3
Fig. 4
Fig. 5
•
Insert the table support crank handle (7) into the worm
gear shaft on the side of the table support (8). Make
sure the set screw (9) is aligned on the flat of the shaft
and as close to the table support as possible. Tighten
the set screw (Fig. 5).
•
Position the table in the same direction as the base,
and tighten the column lock handle (10).
1
2
3
4
5
1
2
4
3
5
6
9
8
7
10
1
2
3
1
2
