1 - Current carrying prongs
2 - Grounding outlet box
3 - Grounding blade is longest of the 3 blades
MOTOR SPECIFICATIONS
In the event of a malfunction or breakdown, grounding provides a path of least resistance
for electric current to reduce the risk of electric shock. This tool is equipped with an electric cord
having an equipment-grounding conductor and a grounding plug. The plug must be plugged into a
matching outlet that is properly installed and grounded in accordance with all local codes
and ordinances.
This Drill Press is designed to use a 1795 RPM motor. It is wired for operation on 110-120 V,
60 Hz. alternating current. Before connecting the motor cord to power source, make certain the
switch is in the “OFF” position and be sure the electric current is of the same characteristics as
stamped on the drill press nameplate.
CONNECTION TO A POWER SOURCE
This machine must be grounded while in use to protect the operator from electric shock.
Plug power cord into a 110-120 V properly grounded type outlet protected by a 15 A dual element
time delay fuse or circuit breaker.
Not all outlets are properly grounded. If you are not sure that your outlet, as pictured in Fig. A, is
properly grounded; have it checked by a qualified electrician.
10
III. Electrical information
Fig. A
1
3
2
DANGER:
To avoid electric shock, do not touch the metal prongs on the plug when inserting
or removing the plug into or from the outlet.
DANGER:
Failure to properly ground this power tool can cause electrocution or serious shock,
particularly when used near metal plumbing or other metal objects. If shocked, your reaction could
cause your hands to hit the tool.
WARNING:
If power cord is worn, cut or damaged in any way, have it replaced immediately to
avoid shock or fire hazard.
Your unit is for use on 120 V; it has a plug that looks
like the one in Figure A.
This power tool is equipped with a 3-conductor cord
and grounding type plug, approved by Underwriters
Laboratories and the Canadian Standards Association.
The ground conductor has a green jacket and is
attached to the tool housing at one end and to the
ground prong in the attachment plug at the other end.
If the outlet you are planning to use for this power tool
is of the two-prong type, DO NOT REMOVE OR ALTER
THE GROUNDING PRONG IN ANY MANNER. Have a qualified electrician replace the TWO-hole
outlet with a properly grounded THREE-hole outlet.
Improper connection of the equipment-grounding conductor can result in a risk of electric shock.
The conductor with insulation having an outer surface that is green with or without yellow stripes
is the equipment conductor. If repair or replacement of the electric cord or plug is necessary, do not
connect the equipment grounding conductor to a live terminal.
Check with a qualified electrician or service personnel if the grounding instructions are not completely
understood, or if in doubt as to whether the tool is properly grounded.