MasterCraft 054-3179, Инструкция по эксплуатации

Страница: 7 / 13

CORDED HAMMER DRILL WITH 50-PIECE ACCESSORY KIT - 054-3179-0 CORDED HAMMER DRILL WITH 50-PIECE ACCESSORY KIT - 054-3179-0
11 12
Auxiliary handle (fig 5)
The tool must be supported with the auxiliary
handle, which can be swiveled and locked into any
of 12 positions, 360° around the collar mount.
To reposition and/or swivel the handle,
1. Unplug the hammer drill from the power
source.
2. Rotate the lower portion of auxiliary handle
counter-clockwise.
3. Push the handle forward until it disengages from the locking teeth in the collar mount.
4. Move the handle to the desired position.
5. Push the handle inward until it engages in the desired position.
6. Securely tighten the auxiliary handle by rotating it clockwise.
Depth-stop gauge (fig 5)
Your drilling depth can be pre-set and/or repeated by using the depth-stop gauge. Setting depth:
Install the auxiliary handle and make sure the accessory has been fully inserted into the chuck before
setting the depth-stop gauge (fig 5).
To adjust the depth:
1. Unplug the hammer drill from the power source.
2. Rotate the lower portion of auxiliary handle counter-clockwise to loosen the depth-stop gauge.
3. Slide depth-stop gauge to the desired position
4. Securely tighten the auxiliary handle by rotating it clockwise.
Speed adjustment dial
(fig 3)
This hammer drill is equipped with a speed
adjustment dial; the required speed may be
adjusted according to the material and the
working conditions.
The speed adjustment dial can be adjusted even if
the drill is running.
For working at low speed, turn the dial
counterclockwise to the “–” position .
For working at high speed, turn the dial clockwise to the “+” position.
Direction-of-rotation selector
(fig 4)
The direction of bit rotation is reversible and is
controlled by a selector located above the trigger
switch. With the drill held toward you:
1. Position the direction-of-rotation selector to
the right of the tool for forward rotation.
2. Position the direction-of-rotation selector to
the left of the tool for reverse rotation.
WARNING!
To prevent gear damage, always allow the hammer drill to come to a complete stop before
changing the direction of rotation.
OPERA
TING INSTR
UCTIONS
OPERA
TING INSTR
UCTIONS
fig 3
Variable-
speed dial
fig 4
Direction-of-
rotation selector
Reverse Forward
fig 5
Locking
teeth
Auxiliary handle
x
Counter-clockwise
Clockwise