Install side assist handle
WARNING:
The side assist
handle must be installed as it will provide
additional control over the drill during heavy
drilling operations.
To install the side assist handle (1), simply thread
it CLOCKWISE into the threaded hole (2) in the top
of the drill (fig. 1).
NOTE:
Never use a wrench or pliers to tighten
the assist handle into the drill. Hand tighten the
handle.
Forward/reverse switch
The forward/reverse switch (1) is conveniently
mounted immediately above the trigger switch on
the drill handle (2) (fig. 2). To make the drill rotate
clockwise for drilling, push the forward/ reverse
switch to the left. To make the drill rotate counter-
clockwise, push the forward/reverse switch to
the right.
NOTES:
a) Never change the position of the forward/
reverse switch while the chuck is turning.
b) The trigger switch will NOT function with the
forward/reverse switch in the middle position.
Variable speed trigger switch
This drill is equipped with a variable-speed ON/
OFF trigger switch.
1.
To start the drill, gently squeeze the trigger
switch (3) (fig. 3).
NOTE:
The drill will turn at its slowest
speed when the trigger switch is depressed
slightly. The drill will turn at its fastest speed
when the trigger switch is fully depressed.
!
OPERA
TING INSTR
UCTIONS
14
2.
To stop the drill, release the trigger switch.
NOTE:
Drilling at a slow speed for an
extended period of time may cause the drill
motor to overheat. If the drill gets hot, stop
drilling and allow it to cool for at least 15
minutes.
Lock-on switch
The lock-on switch is available to hold the ON/
OFF switch in the ON position during prolonged
operation of the drill. To lock the ON/OFF switch in
the ON position:
1.
Squeeze the switch trigger (3) (fig. 4).
2.
While squeezing the switch trigger, press
the lock-on button (4) into the drill handle
(2).
3.
While holding the lock-on button into the
drill handle, release the switch trigger. The
drill will continue to run.
4.
To turn the drill OFF while the lock-on button
is holding the trigger switch ON, squeeze
and then release the trigger.
Installing drill bits
WARNING:
Never hold the
chuck body with one hand and use the drill
power to rotate the drill body to loosen or
tighten bits. Serious injury may result.
1.
Remove the drill plug from the power
source.
!
OPERA
TING INSTR
UCTIONS
15
fig 2
fig. 2
fig 3
fig. 3
fig 4
fig. 4
fig 1
fig.1
LOW GEAR CORDED DRILL 054-1343-0
LOW GEAR CORDED DRILL 054-1343-0