21
DRIVING SCREWS
– cont’d
NOTE:
As the screw is driven into the
wood, the torque required to completely
drive the screw into the wood will increase.
The impact function will allow you to
continue driving the screw until it is fully
nested in the countersunk area.
7. Release the trigger as soon as the
screw is driven to the desired depth.
Failure to release the trigger at this
point will result in an overdriven screw
and possibly twist the head off the
screw.
NOTE:
To remove screws, follow the same
general procedure as for driving screws.
8. Push the forward/reverse button to the
RIGHT for removing screws.
9. Insert the bit fully into the screw head.
10. Hold the impact driver and bit firmly
against the screw head and squeeze
the trigger switch.
NOTE:
The impact action will allow you to
remove tight screws.
INSTALLING NUT DRIVERS FOR
3/16" to 3/8" NUTS
1. Select the correct nut driver size.
2. Insert the hex end (1) into the hex
drive (2) (Fig. 12).
NOTE:
See Fig. 6 for complete procedure.
ASSEMBLY AND OPERATION
Fig. 12
