NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
WHILE CONNECTED TO A POWER SOURCE
© 2018 Pinnacle Climate Technologies, Inc.
Kerosene Forced Air Heater User’s Manual
5
ASSEMBLY INSTRUCTIONS (140T-KFA / 190T-KFA / 215T-KFA)
1. Insert axle through holes in wheel support.
2. Slide spacer onto axle.
3. Slide wheel onto axle and hold in place with the
axle nuts (see Figure 1).
4. Place heater on wheel support and line up holes
on the fuel tank lip.
5. Attach front handle with (2) long screws (50 mm)
and (2) nuts through the second hole from the
front on both sides of the tank lip and wheel sup-
port frame and tighten firmly.
6. Insert (2) short screws (30 mm) through the first
hole from the front in the tank lip and tighten
firmly. Make certain all (4) screws are secure.
7. Attach rear handle with (2) long screws
(50 mm) and (2) nuts through the second hole
from the rear of the heater on either side (see
Figure 2).
8. Tilt the heater up gently so it is resting on the
front handle.
NOTE: DO NOT do this if there is fuel in the tank.
9. Remove the wheels to secure the second set of
screws through the rear handle.
10. Secure the rear handle
with (2) short screws
(30 mm) and (2) nuts
and tighten firmly.
11. Replace wheels and
tighten with the wheel
nuts.
12. Tilt heater back down
onto wheels and check
all screws and nuts to
ensure they are secure.
Figure 1
Axle
Axle Nut
Spacer
Tire
Wheel Support Frame
Figure 2
SPECIFICATIONS
Model #
45-KFA
80T-KFA
140T-KFA
190T-KFA
215T-KFA
Rating: Btu/Hr / kW
45,000 / 13.19 80,000 / 23.4
140,000 / 41
190,000 / 55.68 215,000 / 63.01
Fuel Consumption: Gal/Hr / L/Hr
0.35 / 1.32
0.63 / 2.38
1.1 / 4.16
1.42 / 5.38
1.63 / 6.17
Fuel Tank Capacity: Gallons / Liters
5 / 19
5 / 19
10 / 38
13 / 49
13 / 49
Pump Pressure: psi / BAR
3.0 / 0.21
3.8 / 0.26
6.6 / 0.41
8.5 / 0.59
9.0 / 0.62
Volts: AC/Hz
120VAC / 60Hz
120VAC / 60Hz
120VAC / 60Hz
120VAC / 60Hz
120VAC / 60Hz
Amps
1.4
1.5
2.4
2.7
2.8
Phase
Single
Single
Single
Single
Single
Specifications subject to change without notice.
FEATURES
Hot Air Outlet
Upper Shell
Handle
Extension Cord Wrap
Fan Guard
Pressure Gauge
Fuel Gauge
Fuel Cap
Power Cord
Fuel Tank
Power/Reset Switch
Thermostat Knob
(80T KFA Only)
Lamp
Lower Shell
Upper Shell
Power
Cord
Drain Bolt
Fuel Tank
Pressure
Gauge
Fan Guard
Rear Handle
Digital Temperature
Display
Lamp
Thermostat
Knob
Fuel Cap
Fuel Gauge
Lower Shell
Hot Air
Outlet
Front
Handle