master mechanic 172042, Руководство пользователя

Страница: 12 / 17

12
Fig. 7
Fig. 9
APPLYING WAX TO THE SURFACE TO BE
POLISHED
– cont’d
4.
Start applying wax to the flat surfaces
(hood, trunk and roof) first. Wax one
section at a time (Fig. 7).
5.
After flat surfaces are covered with wax, do
the sides. Hold tool with the extension cord
hanging free (Fig. 8).
6. It is easiest to apply the wax to the entire
surface before starting the removal phase,
however, follow the specific
recommendations of the wax or polish
being used.
7. Turn the buffer/polisher OFF when you
have finished applying wax with the
applicator bonnet.
8. Remove the wax applicator bonnet and use
it to apply polish by hand to all the hard-to-
reach surfaces (under bumpers, around
door handles, etc.) (Fig. 9).
9. Properly dispose of wax applicator bonnet.
ATTACHING THE POLISHING BONNET TO
THE FOAM PAD
1.
Place the terry cloth bonnet on foam pad
(Fig. 10).
2. ALWAYS make sure that the
elastic strip on the bottom of the bonnet is
securely tucked on the underside of the
foam pad.
BUFFING AND POLISHING
– REMOVING THE
WAX FROM THE SURFACE
NOTE: Remove wax in the same order as it was
applied.
1.
Place extension cord over your shoulder.
2. Turn buffer/polisher ON.
Left Right
ASSEMBLY AND OPERATING
Fig. 8
Fig. 10