master mechanic 151997, Руководство пользователя

Страница: 17 / 29

17
TWO-SPEED TRANSMISSION
Set the speed control switch (1) to the
desired speed (Fig. 9). Slide the speed
control switch FORWARD for high-speed
operation. Slide the speed control switch
BACK for low-speed operation.
NOTES:
a) Use low-speed setting for drilling large
holes and for driving screws.
b) Use high-speed setting for drilling small
holes.
c) Do NOT change the speed control
switch position while drill is turned ON.
Damage to the gears may result.
VARIABLE-SPEED TRIGGER SWITCH
This drill is equipped with a variable-speed
ON/OFF trigger switch.
1. To start drill, gently squeeze the
trigger switch (1) (Fig. 10).
NOTE: The drill will turn at its slowest
speed when the trigger switch is
depressed slightly. The drill will turn at its
fastest speed when the trigger switch is
fully depressed.
2. To stop the drill, release the trigger
switch.
NOTE: Drilling at a slow speed for an
extended period of time may cause the drill
motor or the battery pack to overheat. If
either the drill or the battery gets hot, stop
drilling and allow them to cool for at least
15 minutes.
INSTALLING DRILL BITS
WARNING:
Never hold the chuck
body with one hand and use the drill
power to rotate the drill body to loosen
or tighten bits. Serious injury may
result.
ASSEMBLY AND OPERATING
Fig. 10
!
Fig. 9