18
Lighting Your Grill
DANGER: Failure to open lid while igniting the grill or not waiting 5 minutes to allow
the gas
to clear if the grill does not light may result in an explosive flare-up which can cause serious
bodily injury or death
.
Before cooking on this grill for the first time, operate the grill for about 15 minutes with the lid closed
and the gas turned on "high." This will "heat clean" the internal parts and dissipate odor from the
manufacturing processes and painted finish.
Main Burners
1. Read ALL instructions before lighting.
2. Open lid before lighting.
3. Open the LP-Gas Cylinder Valve.
4. Push in main burner control knob fully and rotate slowly about 1/4 turn counterclockwise until a
click is heard.
5. If ignition does not occur, repeat step 5 in rapid succession for no more than 5 seconds or until
burner ignites. If ignition still does not occur, immediately turn the burner control(s) off, wait 5
minutes for the gas to clear and repeat the lighting procedure.
6. Follow same steps to light left and right main burners.
After lighting, observe the burner flame and make sure all burner ports are lit.
If burner flame goes out during operation, immediately turn the gas "off” on the grill and at the gas
cylinder and open lid to let the gas clear for about 5 minutes before re-lighting. Clean your grill after
each use, DO NOT use abrasive or flammable cleaners, as it will damage the parts of this product
and may start a fire.
Side Burner
1. Read ALL instructions before lighting.
2. Open lid during lighting. Lid must be open when burner is on.
3. Burner valves must be in the "off" position.
4. Open the LP-Gas cylinder valve.
5. Push in side burner control knob fully and rotate slowly about 1/4 turn counterclockwise until a
click is heard.
6. If ignition does not occur, repeat step 5 in rapid succession for no more than 5 seconds or until
burner ignites. If ignition still does not occur, immediately turn the burner control(s) off, wait 5
minutes for the gas to clear and repeat the lighting procedure.
7. After burner ignites, adjust control knob to desired cooking setting.
Rear
Rotisserie Burner
1. Read ALL instructions before lighting.
2. Open lid before lighting.
3. REMOVE WARMING RACK BEFORE USING REAR ROTISSERIE BURNER.
4. Open the LP-Gas Cylinder Valve.
5. Push in rear rotisserie burner control knob fully and rotate slowly about 1/4 turn counterclockwise
until a click is heard.
6. If ignition does not occur, repeat step 5 in rapid succession for no more than 5 seconds or until
burner ignites. If ignition still does not occur, immediately turn the burner control(s) off, wait 5
minutes for the gas to clear and repeat the lighting procedure.
OPERATION INSTRUCTIONS