Master-force 260-9509, Руководство оператора

Страница: 13 / 16

Page 13
14. TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Battery clamps do not
spark when touched
together. The charger is equipped
with an auto-start feature.
It will not supply current
to the battery clamps
until a battery is properly
connected. The clamps
will not spark if touched
together. No problem; this is a normal
condition.
The charger will not turn on
when properly connected. AC outlet is dead.
Poor electrical connection.
Check for open fuse or
circuit breaker supplying
AC outlet.
Check power cord and
extension cord for loose
fitting plug.
Green LED is solid
and the display shows
ANALYZING BATTERY .
The charger needs to
check the condition of the
battery. The Green LED will be
solid when the charger is
checking the condition of
the battery. This is normal.
Green LED is flashing
and the display shows
CHARGE ABORTED-BAD
BATTERY
.
The battery is bad.
The battery is too large for
the charger.
Disconnect charger from
the AC outlet and then
remove the clamps. Do
not continue to try to
charge the battery. Have
the battery checked or
replaced.
You need a charger with a
higher amp rate.
The display shows
CONNECT CLAMPS
.
The clamps are
not making a good
connection.
The fuse is bad.
Check for poor connection
at battery and frame.
Replace the in-line fuse
for the ring connector or
12V plug.
15. SPECIFICATIONS
Input Voltage ............................................................................120V AC @ 60Hz, 0.91A
Output Voltage ................................................................................................... 12V DC
Output Current Rating ............................................................................................... 3A