Electrode covered with
7
Trouble shooting
PROBLEM
POSSIBLE CAUSE
PREVENTION/CURE
Wires or
cooking residue
Clean wire and/or electrode with rubbing alcohol
Electrode and burners are wet
W ipe dry with cloth
Electr ode cracked or broken –
sparks at crack
Replace electrode
W ire loose or disconnected
Reconnect wire or replace electrode/wire assembly
W ire is shorting (Sparking
between igniter and elect rode)
Replace igniter wire/electrode assembly
Burner will not light
using igniter
N o gas flow
Check if LP gas cylinder is empty. If empty, replac e or refill,
or else refer to “ sudden drop in gas flow or reduced fl ame
height”
Coupling nut and regulato r not
fully connected
Turning the coupli ng nut about one-half to three quarters
additional turn until solid stop. Tighten by hand only, Do not
use tool s.
Obstruction of gas flo w
Clear burner tubes, check for bent or kinked hose.
Spider webs or insect nest in
venturi
Clean venturi
Burner ports clogged or blocked Clean burner ports
Out of gas
Replace or refill LP gas cylinder
Sudden drop in gas
flow or reduced
flame height
Excess flow, safety device may
have been activated
Turn control knobs to “O F F ”, wait 30 seconds and light
barbecue. If flames are still too low, reset the excessive flow
safety device by turning control knobs “OFF ” and L P gas
cy linder valve to “CLOSED”. Disconnect regulat or. Turn
control knobs to “H IG H ”, wait 1 minute. Then turn control
knobs to “OFF”, and reconnect regulator and leak check
connections . Slowly turn LP gas cylinder valve to “OPEN”,
wait 30 seconds and then light barbecue per lighting
instructions.
Burner ports are clogged or
blocked
Clean burner ports.
New burner may have residual
manufacturing oils
Burn barbecue for 15 minutes with the lid closed
Spider webs or insect nest in
venturi
Clean venturi
Food
residue,
grease
or
seasoning salt on burner
Clean burner
Poor alignment of valve to
injector venturi
Assure burner venturi is properly engaged with injector
H igh or gusting winds
D o not use barbecue in high winds
Low on LP Gas
Replace or refill LP gas cylinder
Excess flow valve tripped
Adjust (lower) temperature accordingly
Grease trapped by food buil dup
around
burner system
Turn control knobs to “O F F ”, T urn L P gas tank valve to
“CLOSED”.
Leave lid in closed position and let fire burn out.
After barbecue cools, remove and clean all parts
Flashback (fire in
burner tube(s)
Burner and/or burner tubes are
blocked
Clean burner and/or burner tubes
Inside of lid is peeling
(like paint peeling)
The lid is stainless steel, not
painted
Baked on grease buildup has turned to carbon and is flaking
off. Clean thoroughly.
Burner will not light
with match
Irregular flame
pattern, flame does
not run the full
length or burner
Flame is yellow or
orange
Flame blow out
Persistent grease
fire
Please retain this manual
for future reference
Produced in China
3+1 Burner gas grill
Assembly instructions
