2
Tools
The following tools may be needed for
installation of your microwave oven.
Phillips screwdrivers, Electric Drill
Motor, 1/2” & 5/8” Wood Bits & 3/16”
Drill Bit, Saw to cut exhaust opening, (if
needed) or Jig Saw, Tin Snips (if
needed), Pencil, Tape Measure, Paper
Tape & Duct Tape.
Installation Hardware
Your Over-the-Range microwave oven
requires mounting space on a wall as
shown.
1. A minimum of 30” between wall
hung side cabinets is required for
installation. Make sure the bottom
edge of the top cabinet is at least 66”
from the floor and 30” from the
cooking surface. And the depth of
the cabinet is required less than 12
inch. (max.12inch)
2. For easier access to the hood lamp,
the bottom of the microwave oven
should be at least 2” above the range
backsplash.
3. If you are going to vent your
microwave oven to the outside, see
exhaust duct preparation.
4. Designed to be installed in 30” wide
cabinet opening.
66" or more
from the floor to
the top of the
microwave
oven
30" more than
from cooking
surface
OTR
Back splash
max, 12
"
2"
30"
Mounting Space
The following is a list of parts you may need for installing your Over-the-Range
microwave oven. You will find the installation hardware contained in a packet with the
unit. Check to make sure you have all these parts. Use this time to become familiar
with each piece.
Image
Part & Description
Q’ty
Image
Part & Description
Q’ty
Lag screws
3
Top Cabinet Template
1
(1/4”
x
2”)
Toggle Bolts and Nuts
3
Rear Wall Template
1
3/16
x
3”
Cabinet Mounting Bolts
3
Installation Manul
1
1/4”
x
3-1/8
Washer (3/4”)
3
Use and Care Manual
1
Nylon Grommet
2
Roller Guide
1
(for metal cabinets)
Damper
1
Grease Filters
2
Top Cabinet
Template
Wall Template
Use and
Care
Manual
Installation
Manual
