Master Chef H405, Инструкция по безопасному использованию, уходу и сборке

Страница: 7 / 24

5
P R I O R T O U S I N G
C A U T I O N
S P I D E R A L E R T
If you notice that your grill is getting hard to light or that the flame is not as strong
as it should be, take the time to check and clean the venturis.
In some areas of the country, spiders or small insects have been known to create
“flashback” problems. The spiders spin webs, build nests and lay eggs in the grill is
Venturi tube(s) obstructing the flow of gas to the burner. The backed-up gas can
ignite in the Venturi behind the control panel. This is known as a flashback and it
can damage your grill and even cause injury.
To prevent flashbacks and ensure good performance the burner and Venturi
assembly should be removed from the grill and cleaned before use whenever the
grill has been idle for an extended period.
Drawing F
Drawing G
W A R N I N G
Natural Hazards
Insects and Spiders
Do not use your barbecue until you have carefully read and fully understand
all the information in this manual. Please ensure the following:
•
Your barbecue is properly assembled.
•
There are no leaks in the system (see “Leak Test”).
•
The burner is properly assembled, with the venturi tubes seated over the
valve outlets (drawing F) and that there is nothing blocking the venturi
tubes (drawing G).
•
Ensure that all power cords and/ or gas supply hoses will not touch or be
near the surfaces that will get hot.
•
The barbecue is in a safe location (see installation).
Ensure that the valve outlets (igniter electrode) are assembled into the venturi
tubes approximately 6 mm (1/4˝) and that the valve outlets and venturi tubes are
approximately parallel to the bottom of the lower body.
During shipment or storage, it’s possible that small insects like spiders could
find their way into the venturi tubes and nest or make webs. This could block
the flow of gas through the venturi tube causing a smoky yellowish flame, or
prevent a burner from lighting. It could even cause the gas to burn outside the
Venturi tube, which could seriously damage your grill. If these occurs, turn off
the gas flow and wait for the barbecue to cool down. When the barbecue has
cooled, remove the burner and clean out the venturi tubes with a brush or pipe
cleaner. Replace the burner and ensure that the venturi tubes are seated over
the Igniter Electrode located on the gas valves. Cleaning the venturi tubes
should be conducted periodically, especially at the start of the season.
Note: Damage resulting from blocked venturi tubes is not covered under
the warranty.
Insert valve outlets into Venturi tubes
approximately 6mm (1/4”)
Valve
Lift Out
Burner Assembly
Clean Out Venturi
Spider Webs
Inside Venturi
Remove
Burner Clips
Air Shutter Venturi
Spider Webs
inside Venturi
Gas Collector
Box & Ignitor
Burner
Control
Panel