GC2610 Back-hoe Operation
The deluxe GC2610 cab is designed for the rear window to be easily removed to allow back-hoe
operation. Remove the three lobe knobs at the bottom of the rear window and slide window
out from underneath the top window retainer. Store window carefully in a dry cool place if
possible, re-install the three lobe knobs back onto cab so that the fasteners do not get lost.
After your ROPS Cab has been installed:
Before starting a tractor equipped with a Tektite ROPS cab:
1. Clear the operator platform of all tools. Tools left in or around the ROPS and tractor can
cause operator interference which could lead to bodily injury and/or damage the machine.
2. Inspect the ROPS and tractor to ensure all bolts are tight and re-tighten if required.
3. Ensure that all pedals, levers, and controls have adequate clearance for normal operation.
4. Ensure that all electrical components of both the ROPS and tractor operate normally.
5. Ensure your door latches properly onto the striker pin. Immediately after installation, the
ROPS frame may flex slightly from installation, and the door latch will need to be re-aligned for
proper operation. Loosen the striker pin, striker mounting plate and door latch as necessary to
get a proper alignment of the door striker.
Service Parts Breakdowns:
Following are parts breakdowns for components that may require service parts replacement
during the life of the ROPS. If you require replacement parts, please contact the dealer that
you purchased the ROPS from and indicate which parts you require.
Please note that both the deluxe and economy breakdowns are included with this manual.
June 2021© Massey GC2610 Series ROPS Cab Operation Manual